Canon LV-X6 - Manual (Page 13)

4
1. Introduction
ᕣ Part Names of the Projector
MEN U
BA CK
KEYSTONE
W ARNING
PO W ER
AU TO PC
IN PU T
LA MP
-
+
VOL
VOL
S-V IDEO IN
VID EO IN
SERV ICE P ORT AU DIO IN
AUD IO O UT
R
L
AUD IO IN
AN ALO G IN -1
AN ALO G IN -2
M EN U
BA CK
KE YST ONE
WARNING
POWE R
AUT O P C
INPUT
VOL -
VOL +
LA MP
Zoom Lever
(See page 24 )
Controls
(See page
6 )
Lens Lens Cap
Be sure to remove the lens cap during
projection. The cap can deform or fire
can occur.
Built-in Security Slot ( )*
Focus Ring
(See page 24 )
Adjustable Tilt Foot Lock Button
(See page
23 )
Adjustable Tilt Foot
(See page
23 )
Remote sensor
(See page 10 )
Ventilation (inlet) / Filter Cover
(See page
51 )
Do not block this vent.
Troubles or fire can result.
Two filters on LV-7250
One filter on LV-X6
Ventilation (inlet)
Front/Top
AC Input
Connect the supplied power cord’s two-pin plug here, and
plug the other end into an active wall outlet. (See page
19 )
Main Power Switch
When you plug the supplied power cord into an active wall outlet
and turn on the Main Power, the POWER indicator turns orange
and the projector is in standby mode.
(See page
20 )
Remote sensor
(LV-7250 only)
(See page
10 )
Terminal Panel
(See page 7 )
Monaural Speaker
(1W)
Rear
* This security slot supports the MicroSaver ® Security System. MicroSaver ® is a registered trademark of
Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.
Ventilation (outlet)
Heated air is exhausted from here.
Do not block this vent. Troubles or
fire can result.