Danby DKC146SLDB - Manual (Page 8)

Installation Instructions
ELECTRICAL
CONNECTION (cont) This Beer Dispenser requires a standard 115/120-volt, 60Hz electrical
outlet with three-prong ground receptacle. The cord should be secured
behind the Beer Dispenser and not left exposed or dangling to prevent
accidental injury.
Never unplug the Beer Dispenser by pulling the power cord. Always grip
the plug firmly and pull straight out from the receptacle.
CO2 GAS CAN BE DANGEROUS
CO2 cylinders contain high-pressure compressed gas which can
be hazardous if not handled properly. Make sure you READ and
UNDERSTAND the following procedures for CO2 cylinders
BEFORE INSTALLATION.
WARNING
1. ALWAYS connect the CO2 cylinder to a regulator. Failure to do so
could result in explosion with possible injury when the cylinder valve is
opened.
2. NEVER connect the CO2 cylinder directly to the product container.
3. ALWAYS follow correct procedures when cylinders are changed.
4. ALWAYS secure the cylinder in an upright position.
5. NEVER drop or throw a CO2 cylinder.
6. ALWAYS keep a CO2 cylinder away from heat. Store extra cylinders in
a cool place (preferably 70°F). Securely fasten with a chain in an
upright position when storing.
7. ALWAYS ventilate and leave the area immediately if CO2 leakage has
occurred.
8. ALWAYS check the D.O.T. test date on the cylinder neck before
installation. If over five (5) years, do not use, return cylinder to gas
supplier.
9. NEVER connect a product container unless there are two (2) safety’s in
the pressure system:
a. One at or on the CO2 regulator
b. One at or on the product coupler or in the pressure gas line.
Beer Keg Installation Instructions
CO2 TANK
RED PRESSURE HOSE
KEG
AMERICAN
SANKEY TAP
CLEAR HOSE
WITH WING NUT
TOWER
FAUCET ASSEMBLY SINGLE GAUGE
PRESSURE
REGULATOR
TOWER
Keg Installation Sketch
• Install the four castors with lock provided into the unit’s bottom (four
screw holes pre-supplied) The two metal gaskets are used for the front
two Castors. Figure (1) before installation. Figure (II) is the final version.
METAL
WASHERS
Figure 1 Figure 2
7