Digicom Vepro Remote Videoalarm User Manual
Page 2
![background image](/manuals/72716/2/background.png)
For further information visit our
website
http://www.digicom.it
Vepro constantly controls the presence of sensors
and videocameras and in case of alarm (generated by
sensors), it captures the images coming before and
after the alarm and sends them immediately to the
control center to analyse the situation.
Vepro can be used also as a local videosurveillance
system togheter with a specific storage unit equipped
with an hard-disk.
In this way all the system can be remote viewed, at
any time,through the EDGE connection or via LAN
(for example through the ADSL router).
The surveillance center can display on the PC the events
that caused the alarm or verify the live situation.
If a broadband connection is available (ADSL, UMTS),
also the remote listening will be possible through the
microphone on the videcamera.
TECHNICAL FEATURES
l
Built-in Class 10 EDGE/GPRS communication device
l
Built-in 54 Mbps Wi-Fi module
l
Built-in 433 MHz receiver
l
1 input
l
1 output
l
Management of I/O input for alarms and activations
l
Mailing of Pre & Post alarm images
l
Management of MJPEG images
l
Images resolution: 640 x 480 pixel max
l
Management of up to 4 Wi-Fi videcameras (54 Mbps)
l
Management of up to 20 SMART sensors
l
Anti-Tamper
l
10/100 4 ports switch
l
Internal Back-up Battery
l
Built-in sound buzzer
SMART SENSOR
l
433 MHz Wireless sensor
l
Wired magnetic REED
l
Vertical TILT sensor
l
Sensors status check (magnetic and TILT) every seconds
l
Alive message every 30 seconds
l
Unique sensor via MAC address
l
Battery low indication
l
Long-Life battery (more than 1 year)
IP Camera 300
Smart Sensor
Vepro
Control Center
(MPEG-4)
Images Storage Server
(FTP Server)
INTERNET
EDGE/GPRS