4^ troubleshooting, Electric diagram – NewAir ACP-1000E User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4^ Troubleshooting
Before investing in repairs, double check the following:
Problems
Causes
Suggested Solutions
The unit doesn't work
Power trouble
1.
The power cord is not plug^
gedin
2. The circuit breaker has
been tripped
a.There is something wron^
with the socket or outlet
4,Tha fuse needs to be repl
aced or the power cord is
damaged
1.
Connect the power cord corre
ctly
2. Resetthe circuit at the breaker
box
3. Change the socket or outlet
4. Take the unit to a qualified techn
ician and have the fuse replaced
(fuse specification: 3A/25DV)
The unit stops working on its own
The timer has activated or the
temperature in the room is
lower than the set temperature
Turn the timer off or wait for the
room temperature to rise
No cool air while in cooling mode
1 .The room temperature is
lower than the set temp
erature
2.The evaporator is frosted
over
1
.Normal operation
2. Allow the evaporator to defrost,
it will then resume normal
operation
No cool air while in dehumidi tying
mode
The evaporator is frosled, the
unit is eliminating froBt
After the evaporator defrosts,
normal operation will resume
Error code E2 is displayed on the
panel
The water tank is full
Empty the water tank and restart
the unit
Error code E4 is displayed on the
panel
The coil pipe is damaged
Replace the coil pipe
Error code El is displayed on the
panel
1 The voltage is too high or
too low
2.Theunit is damaged
1 .Restart when the voltage is
normal
2.Take the unit for repair service
Note:
If the air conditioner needs repair, never service it by yourself. Please contact
the dealer or a professional repair center for assistance.
1 5
Electric Diagram
c
«
ro
ro
o
o
<]
CD
U
ro
"D
I
"D
13
C/3
m
{-I
m
■n
n)
X
TJ
CD