darTZeel Audio CTH-8550 - Manual (Page 10)

darTZeel CTH-8550 User Manual, version 1.0 Page 10 of 15
9.1. Power on sequence
Here is what you will see on the display screen when powering the darTZeel CTH-8550 on:
10. Full configuration and settings
Press the Menu key “A”, (chapter 6.1, page 7) on the front panel, and then play with the charts…
You can choose the source which will be
routed to the RCA REC outputs.
“Listening” means that you will record what
you are listening to.
The standard screen will display the selected
listening source with its corresponding input
label reversed color: REC = Source
Press + or – in order to set the source which
will be recorded, regardless of the source
you are listening to.
Pressing + or – will change the illumination
of the screen in these four increments:
25% → 50% → 75% → 100%.
Press OK when set.
Press RST return to 100%.
Press ◄ or ► to go to
“Auto-off time” shown hereunder. This section offers many parameter-
setting options, allowing you to
personalize your CTH-8550.
You will be able to set virtually any
parameter for each input, as well as
performing software updates, when
and if available in the future.
The above screen shows the selection of a
source for Record Out. In this case,
whichever line source or phono source you
listen to, the REC outputs will always output
the signal from the source ZEEL 1.
Accordingly, the standard screen will
display “ZEEL 1” label in reversed color,
regardless the source chosen for listening,
indicating “ZEEL 1” is now the default
record output source: REC = frozen on the
chosen source.
Pressing either the “Light” key from the
front panel or the ”Lite” key on the remote
control will toggle the display between
“Display auto-off” ON or OFF.
When this function is ON, the display will
dim after the above-defined time.
Press + or - to choose from 2 to 15 seconds.
Press OK when set.
Press RST to return to factory mode.
Press ◄ or ► to return to illumination level
settings.
PARAMETERS
SEE NEXT PAGE