EarthQuake W1265V - Manual (Page 13)

Operator’s Manual
Viper® 212cc 4-Cycle Engine
Check for parts online at www.ardisam.com or call 800-345-6007 M-F 8-5 13
ENGINE MAINTENANCE
For daily maintenance checks, review “pre-operation inspection”
section.
Lubrication
Choose engine oil that meets or surpasses the latest API service
classification. For temperatures higher than 32º F, use SAE 30 or
SAE 10W-30 motor oil. Use SAE 5W-30 or SAE 10W if temperatures
are below 32º F. DO NOT USE SAE 10W-40 MOTOR OIL.
See page 9 to reference Choosing Oil Type chart.
Oil Maintenance
After the first five hours of operating a new Viper Engine the
oil should be replaced, and every 50 hours of operating time
thereafter. The oil should be changed every 25 hours if used
under severe conditions, such as in high temperatures or under
heavy loads, otherwise changed weekly. Check oil periodically;
do not overfill.
Changing Oil
Be sure the engine is not operating and is located on a level
surface before checking or refilling oil. Engine should be warm
for easy removal of oil.
1. Detach spark plug cap/wire and move away from spark plug.
SEE FIGURE 11
2. Remove oil drain plug and empty oil into suitable oil
container. Dispose of oil properly. SEE FIGURE 12
3. Reinstall drain plug. Remove dipstick (if applicable) or oil fill
cap. SEE FIGURE 12
4. Fill with appropriate oil to FULL or top line of dipstick;
otherwise to top thread of oil fill hole. SEE FIGURE 12
NOTE: Oil capacity is 0.63 qt / 20.2 oz. See above, under
lubrication, for correct engine oil grade.
5. Reinsert dipstick or oil fill cap and tighten.
CAUTION
OIL IS HAZARDOUS WASTE
AVOID INJURY! ENGINE OIL IS HAZARDOUS TO YOUR
HEALTH. DISPOSE OF OIL APPROPRIATELY. USE A
SAFE DISPOSAL/RECYCLING CENTER.
CAUTION
RUNNING ENGINE WITH AN LOW OIL LEVEL WILL
CAUSE DAMAGE TO YOUR ENGINE. THIS TYPE OF
DAMAGE IS NOT COVERED UNDER WARRANTY.
FIGURE 11
upper level
lower level
oil fill area/
dipstick
oil drain plug
FIGURE 12
spark plug
cap/wire