Eurocom X8 User Manual
Page 292
Troubleshooting
8 - 22 Problems and Possible Solutions
8
35. Type “select disk #” (the # is the number of the disk you wish to select and you will need to repeat the
procedure for any of your installed disks) and press <Enter>.
36. The system will then prompt “Disk # is now the selected disk”.
37. Type “clean” and press <Enter>.
38. The system will then clean the data from the selected disk.
39. Repeat the procedure for any other installed disks (type select disk # for any other disks).
40. After all the installed disks have been cleaned type “exit” to close diskpart.
41. Proceed with the Windows installation procedure (see your Windows documentation if you need help on
installing the Windows OS).
42. A prompt will appear to ask you to Load Driver.
43. Click Browse and browse to the location you copied the files to on your USB Flash drive or external USB hard
disk (X: denotes your USB Flash drive or external USB hard disk):
• X:\f6flpy-x64 (Windows 8.1 64bit)
44. Click Next.
45. Follow the on-screen instructions to install the Windows 8.1 operating system.
46. Install the Windows drivers from the Device Drivers & Utilities + User’s Manual disc as per
(make sure you install the Intel Rapid Storage Technology driver - see overleaf).
47. Run the Intel® Rapid Storage Technology application to manage your RAID volume as instructed in
Rapid Storage Technology for RAID Systems” on page 7 - 67
.