FeiYu Tech FY-Panda2 Autopilot - Manual (Page 22)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
21
First you should set the correct mounting direction according to the Panda2
mounting direction on the plane(The default setting is Arrow forward).Click on the
button "Inst Setting" after you choose the correct mounting direction. After that, pitch
and roll inclined the plane through the attitude Chart to check whether the posture and
aircraft state is identical. "Teleme Rata" refers to the flight control data downlink
frequency. "RC Rate" means the remote control frequency when using the Remote
Adaptor. We suggest you use the default value for these two parameters, if you set the
value is too big. it will obstruct the Data radio communication and can not
communicate at all.
Connect Panda2 to our GCS software
When you finish the flight control system installation and power on the whole system.
Please choose the right COM"X"(Like:COM1),baud rate:19200 and click on "Connect"
button, this time will pop-up a dialog, ask you to enter a file name which used to keep
records of the flight trajectory. For example we input the file name "test", click on for
sure, the trajectory will be saved into "test.log" file. And you should be able to see the
flight data like attitude, altitude ,voltage, etc. on the left side of our GCS software.