GoDEX EZ Viewer - Manual (Page 13)

12
Chapter 3- Setting
3-1. EZ-Viewer Setting Mode
In the Setting Mode, changes can be made according to requirement on the printing mode, options, media type,
and parallel interface (printer can only go into the Setting Mode when connected to PC by parallel cable, USB
cable, or serial cable).
1. Make sure the printer is powered off.
2. Please refer to section 2-3 to connect the EZ-Viewer to the EZ-1000 / EZ-1000Plus.
3. Install label and ribbon according to the Ribbon & Label Installation Diagram, and turn the printer power back
on, and make sure the Ready light is green.
4. Press and hold the”Pause” key on the EZ-Viewer, then press the”Feed” key. Hold these two keys for about 3
seconds and release them, the LCD Display will then show ”Setting Mode.”
5. In the Setting Mode, the EZ-Viewer keys have the following functions:
Feed Key: Selection
Pause Key: Enter or confirm
Cancel Key: Exit
6. Before exiting the Setting Mode, printer will prompt user whether or not to save the settings. After user’s
response on whether or not to save the settings, printer will return to standby mode.
Darkness
Default: 15
Set the darkness of printing result. The setting value is from 0 to 19 and the
default value is 15.
Speed Set the speed of printing.
Adjust Stop Position
Default: 0
Set the stop position of printing. The setting value is from 0 to 10.
Printhead Position
Default: 0
Set the position of print head when printing. The setting value is from -100 to 100.
Printing Mode
Default: Thermal Transfer
Thermal Transfer: when printing, the ribbon must be installed to transfer the
print contents onto the media.
Direct Thermal: when printing, no ribbon is necessary; it only requires direct
thermal media.
Option Setup
Default: Option OFF
Strip Mode: turn on the stripper function
Cutter Mode: turn on the cutter function
Applicator Mode: turn on the applicator function
None: select this to turn off the stripper and cutter functions.