Grandview LF-PP(Large-Flat Ultimate 100 mm Series) - Manual (Page 4)

3 4
4. Unfold screen fabric and insert tension bars. Use the long bar for the top & bottom and the short bar
for sides. Be careful not to poke the fabric (Figure 8-10).
5. Align fixing lugs with arrows. Using the tension bar, pull fabric eyelets over fixing lugs. Do top side
first then rotate clockwise (Figure 11-15).
6. Adjust screen to ensure that it is flat and smooth.
7. Align brackets to desired width and measure. Drill two, or four holes (If using 4 brackets) in wall at
measured width. Insert 5x40mm screws for studded wall, or 5x40mm screws + anchors for drywall
without studs and hang (Figure 16-17).
Figure 9 Figure 10
Figure 8 6mm Tension Bars
Figure14 Figure15 Figure13
Figure 11 Figure 12
Figure16 Figure17
8. Insert 6x12mm screws to fasten the brackets to the top and bottom frames. 9 (Figure 18-1 )
Figure 18
Figure 19