Grandview 1GD-IRAnIII(IR Remote Control) - Manual (Page 2)

1
2
3-4
2
5
Contents
Safety Information
Working Principle
Installation Guide
Controller Instruction
Contents Diagnosis and treatment for malfunction
Symptom Cause Measure
The instruction LED
light on the receiver
doesn't work
1. Check power.
2. The improper cable connection.
3. Disconnected for fuse in receiver.
1. Make sure connect the power properly.
2. Connect the cable in right way ccording
to Wire circuit diagram.
3. Replace with new fuse.
The instruction light is
working but when you
press the button on remote
controller the light doesn't
twinkle.
1. Batteries in remote controller run out or
wrong direction of fixing the cathode
and anode for batteries.
2. Incorrect cable connection of the receiver;
3. Inappropriate angle or distance of the
remote controller.
4. There is obstacles between emitter and
receiver.
5. The header don't plug with the receiver
tightly.
6. The receiver gets broken.
1. Change the direction of batteries
according to the figure in set up for
controller batteries first,but if the
malfunction still exists then replace
them with new batteries.
2. Pls refer to cable diagram.
3. IR emitter only can work within 8 meters
and 30 degrees in front of the receiver.
4. Pls clean the obstacles between emitter
and header.
5. pls plug the header with the receiver tightly.
6. Contact with Grandview after-sales team
or contact with the local dealer.
Trouble Shooting 6
If the remote control can't work properly, please check it according to the following steps. While if you
can't find the same symptoms and right way to solve the problems please contact with Grandview's
local distributor or our ofter-sales team.