LG Motorsports LG C6 World Challenge Hood - Manual

LG Motorsports
World Challenge C6 Hood
Brought to you by LG Motorsports
972-429-1963
Instructions:
1. Before removing the stock hood, make note of the factory gaps and edges.
2. Cover fenders and nose to prevent any scratches. Tape edges of hood, fenders, and
nose with painters tape to prevent any nicks during fitment.
3. Remove factory hood and place on a safe stand.
4. Install the new hood by only installing the 4 hinge bolts, installing the hood without
the latch and bump stops will help you adjust the hood.
5. Snug the bolts while keeping the hood as forward as possible in its hinge adjustable
range (Hood is vertical at this point). Bolts should just be snug with the higher (in open
position) or rear (in closed position) a tad tighter.
6. Slowly close the hood; try closing at the mid point of the hood to reduce the torque
effect and moving the hinge bolt setting...
7. Once the hood is closed, the front end will be approximately 1/2'' to 1'' higher than the
fascia. Now you can use your hands to add pressure and set the hood flush with the
fender and front fascia.
8. Open the hood about 15 inches and tighten up the hinge bolts.