RODE Microphones Podcaster - Manual (Page 10)

- 10 -
Setting up the Podcaster
Mounting the Podcaster
The Podcaster comes with a stand mount that
will allow you to connect it to a microphone
stand or ‘Anglepoise® style’ arm such as the
RØDE PSA-1.
The mount comes with a 3/8” brass insert that
can be removed. Once removed the internal
thread of the mount is a 5/8” thread. This allows
the mount to be used on either a US 5/8” stand
or pole or a Euro 3/8” stand or pole.
Also on the mount is a thumb screw which when
loosened will allow the mount to rotate to enable
you to angle your microphone to the most
appropriate direction.
To mount the microphone into the clip follow the
steps below.
• Remove the locking collar from the base of
the microphone.
• Slide the base of the microphone into the
hole in the stand mount.
• Screw the locking collar back into position to
carefully secure the Podcaster to the mount.
• Now, loosen the thumbscrew on the stand
mount and adjust the microphone to
the desired angle. Once set, tighten the
thumbscrew to secure the microphone in
place.