Dakota Digital LED Tail Lights LAT-NR350 - Manual

MAN#650204
INSTALLATION INSTRUCTIONS
LAT-NR350
LED Tail Lights for 1964-1966 Mustang
MAN#650204
Kit Includes:
Installation:
1. Remove both right and left tail light lenses as described below at the same time, taking care to
keep the left and right lenses and trim with the correct side of the vehicle.
2. Remove the four screws that hold the chrome tail light trim piece.
3. Remove the tail light trim piece and the lens.
4. Remove the light bulb from socket.
5. Loosen the lens seal from the housing by gently pulling the seal away from the housing.
6. Now is a good time to clean the lenses and the tail light housings. If the lenses are in poor
condition a replacement set is recommended.
7. Make sure the housings and lenses are clean and dry. DO NOT remove backing from tape yet!
Place the light diffuser onto the back of the lens. Check for proper fitment of diffuser to inside
of lens and note the places where the tape touches the lens.