Spectrum Controls 1769sc-IF8u - Manual (Page 39)

Chapter 3: Installation and Wiring 29
3. At one end of the cable, twist the drain wire and foil shield together,
bend them away from the cable, and apply shrink wrap. Then earth
ground at the preferred location based on the type of sensor you are
using. See Grounding for more details.
4. At the other end of the cable, cut the drain wire and foil shield back to
the cable and apply shrink wrap.
5. Connect the signal wires to the terminal block. Connect the other end
of the cable to the analog input device.
6. Repeat steps 1 through 5 for each channel on the module.
NOTE: See Appendix D Using Thermocouple Junctions for additional
information on wiring grounded, ungrounded, and exposed
thermocouple types.
Wiring Diagrams