Spectrum Controls 2080sc-OW2IHC - Manual (Page 8)

Micro800™ 2 Ch High Current Digital Output Module 8
Publication 0100188-01 Rev. A
Module Output Data
The two output channels on the OW2IHC are controlled by memory
location 64, bits 0 and 1 control channels 0 and 1 respectively. See
Table 3 for memory location offsets. The table below describes the state
of each output channel in relation to the control bits.
Table 2 (Output States)
Channel # Bit state Output State
0
0 OPEN
1 CLOSED
1
0 OPEN
1 CLOSED
Adding the OW2IHC to CCW
The 2080sc-OW2IHC is configured for CCW (Connected Components
Workbench) using the PLUGIN_READ and PLUGIN_WRITE instructions
for generic plug-in modules.
The configuration, output data, and status structures discussed in the
sections above, are stored at different memory locations in the module.
The following table lists the memory location offset for each parameter
which is used when configuring the PLUGIN_READ, WRITE, and INFO
instructions.
Table 3 (Parameter Offset)
Parameter
Offset
(Dec) Comments
MOD_ID_LO 0 Module ID
MOD_ID_HI 1
VENDOR_ID_LO 2
Vendor ID
VENDOR_ID_HI 3
PRODUCT_TYPE_LO 4
PRODUCT_TYPE_HI 5
PRODUCT_CODE_LO 6
PRODUCT_CODE_HI 7
MOD_REV_LO 8 Minor revision, 1-255
MOD_REV_HI 9 Major revision, 1-127
CONTR_OPS_STATUS
11
Controller operation status information
(see Table 4)
MOD_STATUS
16
Module status register
(see Table 1)
Micro800™ 2 Ch High Current Digital Output Module 13
Publication 0100188-01 Rev. A
Environmental Specifications
Environmental Tests Industry Standards Test Level Limits
Temperature (Operating)
IEC60068-2-1: (Test Ad, Operating Cold),
IEC60068-2-2: (Test Bd, Operating Dry Heat),
IEC60068-2-14: (Test Nb, Operating Thermal Shock)
-20 to 65°C (-4 to 149°F)
Temperature
(Non-operating)
IEC60068-2-1:
(Test Ab, Unpackaged Non-operating Cold),
IEC60068-2-2:
(Test Bb, Unpackaged Non-operating Dry Heat),
IEC60068-2-14:
(Test Na, Unpackaged Non-operating Thermal Shock)
-40 to 85°C (-40 to 185°F)
Operating Altitude 2000 meters (6561 feet) Not tested
Humidity (Operating)
IEC60068-2-30:
(Test Db, Unpackaged Damp Heat):
5 to 95% non-condensing
Vibration (Operating) IEC60068-2-6: (Test Fc, Operating)
5G
Shock (Operating)
IEC60068-2-27: (Test Ea, Unpackaged Shock) 10 g
Shock (Non-operating) IEC60068-2-27: (Test Ea, Unpackaged Shock) 50 g
Radiated Emissions CSIPR 11; Group 1, Class A 30MHz – 1GHz
Conducted Emissions
IEC 61000-6-4:2007
Group 1, Class A (AC Mains)
150kHz – 30MHz
ESD immunity IEC 61000-4-2
4kV Indirect (Coupling Plate)
4kV Contact Discharge (to points
of initial contact)
8kV Air Discharge (to points of
initial contact)
Radiated RF immunity IEC 61000-4-3: Level 3
10 V/M with 1 kHz sine-wave
80%AM from 80…2000 MHz
10 V/M with 200 Hz sine-wave
50% Pulse 100%AM @900 MHz
10 V/M with 200 Hz sine-wave
50% Pulse 100%AM @1890 MHz
3 V/M with 1 kHz sine-wave
80%AM from 2000…2700 MHz