Dynasty Spas Deluxe System D-1000 User Manual

Page 30

Advertising
background image

Low water flow

Spa is leaking

Motor does not run

Motor runs hot

Probable Cause #1

Action

Dirty Filter

Remove filter cartridge and clean.

Probable Cause #2

Action

Probable Cause #3

Action

Closed gate valves or blocked lines.

Open all gate valves.

Low voltage or incorrect voltage

Have a Licensed Electrician check the line voltage

Probable Cause #1

Action

Loose connection.

Hand tighten all disconnects and fittings.

Check joints and unions

Probable Cause #1

Action

No power to motor.

Check power switches and circuit breakers. Check

motor plug where plugged into control panel.

Probable Cause #1

Action

Pump ran dry.

Call dealer for recommended action.

Note: These motors will feel hot to the touch. This is normal. The

Overheat sensor will turn the motor off if there is an overload or

high temperature problem.

Probable Cause #2

Action

Pump jammed from foreign matter in impeller.

Call dealer for recommended action.

Probable Cause #2

Action

Restricted suction lines

Make sure all valves are open/clear suction of debris.

Probable Cause #3

Action

Motor overheats during hot days while filtering.

Re-program your controls to cycle during the

coolest parts of the day and on shorter cycles.

(see programming instructions)

T r o u b l e S h o o t i n g G u i d e ( c o n t . )

30

Advertising
This manual is related to the following products: