Turning Technologies TurningPoint 5 - Manual (Page 20)

Did you know unit IDs may also
be modified via ResponseCard
Programmer? Please contact your
sales representative for more details
or visit TurningTechnologies.com.
Modifying Unit ID Manually
Unit ID as displayed on the reverse side of the device.
1. Press the Toolbox (right function key).
2. Press the right arrow key until “Device Info” is displayed.
3. Press the
Enter button.
Note: The next 3 steps must be completed within 3 seconds.
4. Press the button twice.
5. Press the button.
6. Press the
Enter button.
7. Enter the new Unit ID (up to 6 digits).
8. Press the
Enter button to save the new Unit ID.
abc
Reverting to Factory Default Unit ID
1. Press the Toolbox (right function key).
2. Press right arrow key until “Device Info” is displayed.
3. Press the
Enter button.
Note: The next 3 steps must be completed within 3 seconds.
4. Press the button twice.
5. Press the button.
6. Press the
Enter button.
7. Enter 000000.
8. Press the
Enter button to reset to the factory default Unit ID.
abc
responsecard
nxt
unit
id
programming
Unit ID Programming (Optional)
ResponseCard® NXT
ResponseCard NXT
Enter
1 2
41