Vortech 2006-2010 6.1L Hemi Cars (Charger, Challenger, Magnum, 300C) User Manual
Page 33
P/N: 4CL020-010 v6.0, 02/28/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
19
M. Reinstall the rear seat, door sill, and under dash
cover at this time.
N. On the FPB box, locate the red 12 ga. wire with
fuse holder. Cut off the fuse holder and discard.
Locate the 12 ga. red wire provided and con-
nect where fuse holder was cut off. Locate the
provided black 12ga. wire and connect to the
black wire on the FPB.
O. Route the red power wire and black ground wire
toward the fuse box next to the battery. Trim the
wires to proper lengths to attach to factory ground
lug and factory power distribution box. Locate
the provided fuse holder and cut the center of
the wire loop. Attach one end to the red 12 ga.
power wire from FPB. Use the supplied ring
terminals crimp, solder, and attach to factory
lugs. (See Figs. 11-e, 11-f, 11-g for close up
view.) Install the supplied 40amp fuse into fuse
holder after all connections are complete.
P. Reinstall the trunk organizer and carpet at this
time.
11. FUEL PUMP VOLTAGE BOOSTER INSTALLATION con’t
Fig. 11-e
Fig. 11-f
Fig. 11-g
GROUND LUG
POWER WIRE
TERMINAL