Vortech 1994-2001 Acura Integra GSR User Manual
Page 18
P/N: 4HC020-030
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN04v2.1(Acura Integra LS (4HC..030v2.1))
10
11. SUPERCHARGER INSTALLATION, cont’d.
Fig. 11-g
Fig. 11-f
Fig. 11-e
G.
Lower the supercharger into the engine compart-
ment. Align the three-pin coupling on the super-
charger with the three-pin coupling on the
installed drive shaft assembly and connect them
using the supplied composite drive coupling ring
(6 holes). Verify that each set of pins is inserted
into the raised bosses on their corresponding
side of the composite ring. Align the holes so that
one side of the pins alternate with the opposite
side of pins. (See
Figs. 11-d, 11-e.) Slide the two
assemblies together until a positive stop is felt
and the couplers are flush with the composite
drive coupling ring.
H.
Loosely install the three supplied M8 x 55mm
screws through the mounting plate and into the
engine block.
I.
Align the coupler housings and secure them to
the supercharger gear case using the supplied
5/16-18 x 5.25" HXHD screws with washers.
Snug the screws at this time
J.
Tighten the supplied M8 x 55 screws securing
the mounting plate to the engine.
K.
Route the free end of the oil feed hose to the
supercharger and attach.
L.
Attach the free end of the oil drain hose to the
previously installed oil drain tube. Make sure that
the oil drain hose and tube are constantly slant-
ing down towards the oil pan.
M. Tighten the oil drain tube nut in the oil pan fitting.
Tighten the oil drain hose clamp.
N.
Carefully bend the clutch line until it runs next to
the oil feed fitting. Using a small section of hose
to keep the tube from touching any metal ob-
jects, secure the tube to the oil feed fittings.
O.
Relocate the ground strap bracket as shown in
Fig. 11-f using one of the original bolts.
P.
Trim the A/C support, leaving the threaded nut
insert intact. Install the bracket in its original
location.
Q.
Remove the clamp from the A/C lines and
reinstall it upside down. Re-attach to the trimmed
bracket. (See
Fig. 11-g.)
Fig. 11-d
COMPOSITE DRIVE
COUPLING RING