Naim Audio SuperUniti - Manual (Page 8)

6
2. Installing and Connecting
2.8.2 Wireless Network Connection
If your Uniti Series product is to connect wirelessly to the
home network, the supplied Wi-Fi aerial must be fitted to
the rear panel Wi-Fi aerial socket. Wireless configuration
will also be necessary before network connection can be
made. See Section 4.7.1.
Note: The Wi-Fi aerial is the longer of the two supplied.
2.8.3 Network Settings
Uniti Series products are set up when originally shipped not
to require any on-site network configuration but to connect
to networks automatically (DHCP is used by default).
However, if your Uniti Series product has been previously
used, its network configuration may have been altered
leaving it unable to connect automatically. If this appears
to be the case ensure that DHCP is selected in the Network
Settings menu and re-start the unit. If the problem still
persists carry out a Factory Reset operation (by selecting
Reset All Settings from the Factory Settings setup menu)
and try again.
Note: Wireless configuration data and user radio presets
will be deleted during the Factory Reset operation.
2.9 Bluetooth
Uniti Series products are able to play Bluetooth audio
streams from Bluetooth capable devices incorporating
an appropriate audio playback app. The Bluetooth aerial
supplied must be fitted to the rear panel Bluetooth aerial
socket.
Note: The Bluetooth aerial is the shorter of the two
supplied.
2.10 Control and Update Sockets
Uniti Series products are fitted on their rear panels with a
variety of rear panel control and update interface sockets.
• Remote In and Out sockets can be used for RC5 remote
control via a wired connection or a remote IR repeater.
• Mini-USB sockets enable firmware upgrades and
diagnostic tests to be carried out. Contact your Naim
retailer for more information if required.
Note: The mini-USB interface is not intended for the
connection of USB memory devices.