Dynasty Spas D-3000 - Manual (Page 24)

An Overview
Filter Cleaning
Surface Cleaning
Surface Protection
Water Balance
Sanitizing
Mineral Protection
Foam Control
Aromatic Control
Monthly - For Equipment Protection
As Needed
CALCIUM BOOSTER (If Needed) - Calcium booster treats the water if
low calcium hardness is a problem in your area. It will help prevent
equipment corrosion and foaming by raising the spa's water hardness
level to an acceptable range of 120 ppm.
To keep your filter free of grease, grime, and oil. Clean the filter with
SPA CARTRIDGE FILTER CLEAN. One 16 oz. bottle treats a 55 square foot
filter. See Filter Maintenance section for location and diagram.
Between refills and as needed, clean the surface using SPA MULTI-
PURPOSE CLEANER. For tough scale & stains, use STAIN & SCALE REMOVER.
To protect and seal the spa surface, use SPA FAST GLOSS every time you
drain and clean the spa.
Adjust the pH quickly and easily with pH STABILIZER.
It will properly adjust and hold the pH for up to 3 months.
Note: Not recommended for calcium hardness levels above 200 ppm.
Use SPA UP to raise pH and SPA DOWN to lower pH.
K e e p i n g Yo u r S p a W a t e r C l e a n & F r e s h
Use 2 ounces of SODIUM BROMIDE to create a bromide reserve. When
using BROMINATING TABLETS, 2 ounces will treat up to 500 gallons
of water. For chlorine system, use CHLORINATING GRANULES
(1/2 oz. per 500 gallons).
STAIN & SCALE REMOVER - This prevents staining, rust and corrosion,
caused by metals in the source water. One bottle will treat up to 500
gallons for up to 3 months.
To control foaming, use SPA FOAM DOWN. For added convenience, use
just 3 drops of SPA FOAM DOWN CONCENTRATE.
To make your spa even more relaxing and enjoyable, add ESSCENTS
fragrance to it as often as you desire. With 8 exotic scents to choose from,
you'll be sure to discover one that sets the perfect mood for you.
24