Drylam SL27 Roller Laminator - Manual (Page 9)

C. Threading the Film
Remove the feed tray and the heatguard. Thread the film as
shown in the figure on the right. Pull the film around the idler
rollers as shown. Do not mistake the reinforcing bar for the
idler roller. Make sure the glossy and dull sides of the film
are as indicated in the diagram. Position the threading board
provided.
Turn power and keyswitch to on.
Start the motor by pressing the “Fwd” but-
ton. Feed the threading board and film in
between the heat shoes. This will pull the
film through the rollers until it comes out
the back of the laminator.
Slide the top and bottom film rolls from side
to side on the mandrels so that the film is
perfectly aligned top and bottom (Note:
overlap will cause the film to deposit resi-
due on the heat shoes and rollers, so this
procedure is critical). Replace feed tray
and heat guard.
7
DULL SID
E S H I NY S
I DE
DUL L S I D
E
S H I N Y S
I DE