Drylam Fujipla ALM3222 User Manual
Page 51
AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page 51 of 63
PROCEDURE:
1. Loosen the Paper Feed Resist Roller Pressure Adjust knob and adjust in small 1/8” increments
(or, about one mark at a time on appropriate labels) as follows:
a. If too many sheets are being fed at once loosen and slide the knob upwards.
b. If sheets are slow to enter, or will not enter at all (enough that “LAMINATION ERROR”,
or other similar errors occur) loosen and slide the knob downward.
2. Tighten the knob.
HINT: If sheets are not being pulled off the tray completely (with “FEEDER ERROR” or “LAMINATION
ERROR” displayed, adjust the knob downward. If more than one sheet is drawn in consistently, move the
knob upwards.
Try small adjustments of 1/8”, or less, until the optimum setting is found for the paper stock being
laminated. This adjustment should be performed in conjunction with the Paper Feed Adjust (Software)
parameter in the menu.
HINT: When “Lamination Error” and “Feeder Error” appear frequently adjust this knob downward
slightly (in small 1/8” increments). For best results use this adjustment along with the Paper Feed Adjust
parameter in the Mode Menu.
HINT: This is a compatibility adjustment. There is no “perfect” or “standard” setting. Different paper
stocks and toners will have different characteristics. Experimentation is key. It is better to have the
occasional sheet NOT drawn off the tray (i.e. adjustment knob set too high) than it is to have too many
sheets drawn from the tray and jamming within the machine (i.e. adjustment knob set too low).