NEXCOM NISE 4000 - Manual (Page 90)

Copyright © 2014 NEXCOM International Co., Ltd. All Rights Reserved. 75 NISE 4000 User Manual
Chapter 4: BIOS Setup
AMT Configuration
This section is used to configure Active Management Technology (AMT)
options.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable/Disable Intel (R)
Active Management Technology
BIOS Extension.
Note : iAMT H/W is always
enabled.
This option just controls the
BIOS extension execution.
If enabled, this requires
additional firmware in the SPI
device
Intel AMT
BIOS Hotkey Pressed
MEBx Selection Screen
[Enabled]
[Disabled]
[Disabled]
Intel ® AMT
Enables or disables Intel ® Active Management Technology.
BIOS Hotkey Pressed
Enables or disables BIOS hotkey pressed.
MEBx Selection Screen
Enables or disables MEBx selection screen.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enables Legacy USB support.
AUTO option disables legacy
support if no USB devices are
connected. DISABLE option will
keep USB devices available
only for EFI applications.
USB Configuration
USB Devices:
2 Drives, 1 Mouse, 2 Hubs
Legacy USB Support
USB3.0 Support
Mass Storage Devices:
Hitachi HTE543232A7A384 3.00
ASMT 2105 0
[Enabled]
[Enabled]
[Auto]
[Auto]
Legacy USB Support
Enable Enables Legacy USB.
Auto Disables support for Legacy when no USB devices are connected.
Disable Keeps USB devices available only for EFI applications.
USB3.0 Support
Enables or disables USB 3.0 controller support.
Mass Storage Devices
Mass Storage device emulation type. “Auto” enumrates devices according
to their media format. Optical drives are emulted as ‘CDROM’ , drives
with no media will be emulated according to a drive type.
USB Configuration
This section is used to configure the USB.