Oklahoma Sound #600 - Manual (Page 4)

O
klahOma
S
Ound
C
OrpOratiOn ARisTOCRAT COnTOuR FLOOR LECTERn: Model 600
4 5
InStallatIOn OF hardware
1) Lay out the wood panels as shown in Diagram A (make sure the
factory drilled holes are facing upwards). You can determine the
top of the front panel by identifying the T molding edge.
2) identify the holes numbered "1" in Diagram A. screw the bolts
into the predrilled holes with the #2 Phillips head screwdriver.
Be sure to tighten the screws all the way. Be careful not to over-
tighten the bolts as this will strip the wood!
3) insert the cams in the larger holes as shown on diagram. MAKE
suRE THE ARROW On THE CAM is POinTinG TO THE CLOsEsT
EDGE AnD ALiGnED WiTH THE HOLE On THE EDGE.
4) insert the 8 wooden dowls into the holes of the edges on the 2
"sHELF RunnER PAnELs".
5) On the "BOTTOM" Panel F screw in the
four casters. The locking casters
should be screwed into the
bottom closest to the shaped
finished edge. The second pair
of non-locking casters should
be attached closest to the
unfinished edge.
6) Screw in the
corner brace to
the side, there
are pre-drilled
holes to guide
you. (Diagram B)
Diagram "A"
aSSembly OF leCtern
It is important that the instructions on the assembly are
followed carefully
1) The first step of assembly will be to align the holes on the
edge of panel edges with the three cam bolts on the side
Panel A. Tighten the cams by turning clock-wise until locked.
2) Take Panel D and Panel E and tighten cams. Make sure the
cams on Panel D and Panel F face the bottom of the lectern.
The two bolts just above the slots align with the two holes
on the edge of Panel D (these holes reach unti the cams). The
two bolts in the center of the right side panel will align with
the two holes on the edge of Panel E. Gently push the panel
down on to the cam bolts until the panel is completely on
the right side panel.
3) Taking the Panel F,
with the casters facing the
bottom of the unit, insert
panel into the groove,
make sure that the
panel is all the way
in the groove.
4) next to be installed will be
the shelf frames. Identify the
runner panel with 1 edge cut
on an angle (Panel G) – refer
to Diagram C. Now the sec-
ond "sHELF RunnER PAnEL"
(Panel H) shall be installed
under Panel D and near Panel
B with the plastic glides fac-
ing the other side.
(Diagram C)
Diagram "B"
Diagram "C"
Angled Edge
A
B
C
E
D
F
G H