DVDO High Definition Video Processor & Hub Edge - Manual (Page 13)

DVDO Universal Remote: Programming the remote using the Preprogrammed Code Method
The Preprogrammed Code Method using 3 digit codes is a simple way to program the DVDO Universal Remote. Other methods are
described fully in the DVDO EDGE Product Manual on the CD.
Programming the remote using the preprogrammed 3 digit code method.
Step 1] Turn on the device you want to operate manually.
Step 2] Press the Device button and the OK buttons simultaneously and hold for 3 seconds until the Device LED turns on. (The LED will
stay on for 20 seconds. The next step must be entered during this period).
Step 3] Point the remote control toward the device and press in the first three-digit Setup Code number for that device using the number
buttons(0-9) on the remote control. (The Device button LED will blink once for each button pressed).
Tip) Your device will turn off when the corrected Setup code number has been selected. If the device does not turn off, press in the next
Setup Code numbers until your device turns off.
If you have tried all of the Setup Code numbers listed and it still did not turn off, please proceed to the Auto Search Method, described in
the DVDO EDGE Product Manual.
Step 4] Once your device turns off, press the Device button selected in the Step]2 once again to store the Setup Code number. (The Device
LED will blink three times to confirm that the code has been stored).
Step 5] Please repeat the above steps to program the remote control for each of other devices.
Code Tables appear on the following pages. A more complete list of tables in available in the DVDO EDGE Product Manual on the CD.
Table names correspond to component buttons on the remote. The table below lists the remote’s component button names and
corresponding code tables.
Component Button Table Name
Aud AV Receivers and audio processors
BD Blu-ray & HD DVD
VCR VCR, TV/VCR Combos
AUX PVR, TIVO, Gaming Systems
TV TV
DVD DVD
Cable/SAT Cable Boxes, Satellite Boxes
13