Zilog Z51F6412 - Manual (Page 39)

UM025901-1112 Build and Run the Z51F6412 Demo Project
Z51F6412 Development Kit
User Manual
32
The following buttons in the Keil µVision IDE are not supported by the Zilog OCD driver:
To learn more about the full functionality of the Keil µVision IDE, please refer to the Keil
Keil µVision4 IDE documentation.
14. From the Debug menu, select Run , or simply press the F5 key on your Windows key-
board to run the demo project. As a result, LEDs D2, D3 and D4 on the Z51F6412
Development Board will blink in sequence.
15. To stop code execution, select Stop from the Debug menu.
16. To stop your debugging session, click the Start/Stop Debug Session icon.
Refer to Appendix C on page 45 for a discussion of Stand-Alone Flash Programming
Using the Keil µVision IDE.
HyperTerminal Configuration
A communications program such as HyperTerminal can be used on Windows XP systems
to view the messages from the Z51F6412 Development Board. The following procedure
examines how to configure HyperTerminal for the Z51F6412 demo project.
The HyperTerminal application is not available in Windows Vista and Windows 7 systems.
If you are using either of these operating systems, consider using/installing different com-
munication software, such as Tera Term. Please refer to the documentation for the particu-
lar emulation software you use to configure it for communication with the Z51F6412
Development Board.
1. In HyperTerminal, select the COM port assigned to the USB-to-UART interface cable
that is connected to the P1 connector on the Development Board.
Note:
Note:
Note: