Analog Way PULSE2 (MIDRA) - Ref. PLS350 User Manual - Manual (Page 58)

58
8.2.17 Capturing logos
To set up your logo you have several features available:
- Position / Size Adjustment
- Keying type
- Luma / Chroma key
- Cut out color.
Select the logo number you want to save and wait until the unit finishes saving. Your logo is now saved and
you can use it through the logo button.
You can save up to 8 logos with the Pulse².
The capture of logos can be done only with the following conditions:
- The capture can be done on the Program output or the Preview output
- The disappearance of logos on the Preview and Program output is normal during saving.
The logos are captured with the same size as is visible on the Program output without any form of adjust-
ments. If zooming is required, resize the layer or use the layer zoom or input zoom.
A logo captures the state of the defined area on the specified output at the Program output resolution, and
must be recalled using the same output resolution. Resizing or other image manipulation of the captured
logo is not possible.
The capture zone is outlined by a white rectangle and includes the pixels beneath the white border. The non-
captured area has a reduced brightness.
Logo capture is limited in the number of pixels being captured. When the logo capture area is resized, exten-
ding the horizontal size may reduce the vertical size to compensate.
Logos can also be captured and displayed with transparent areas. By adjusting the keyer in the logo capture
menu, the portions of the captured area can be keyed away and captured as transparent.
The logo “Cut out color” can help display which portions of the image will be captured as tranparent.
NOTES:
• The cut out color is only a visual tool to help identify the transparent areas of the logo. These colored re-
gions will not be captured but later displayed as transparent area.
• Capturing a “logo” is limited to a small percentage of the output resolution. To capture and display a full
screen image, use the still “frame”.
8.2.18 Capturing an animated logo
To capture animated logo, display the exact content you want to save on the Program screen, you can use the
freeze button. Then follow this step:
Logos/Frames menu > Record Anim menu > Pos/Size adjust > Store menu > logo#8
To set up your animation, you have several features available:
- Position / Size Adjustment
- Keying type
- Luma / Chroma key
- Recording time
- Cut out color