DVS -30-2 - Manual (Page 29)

13369-1-0203 Page 29
4. Push in gas control knob slightly and turn clock-
wise
to "OFF." Do not force.
5. Close louver front assembly.
8. Turn gas control knob counterclockwise to
"PILOT."
9. Push in control knob all the way and hold in.
Immediately light the pilot with the Piezo Pilot
Ignitor or use a match. Continue to hold the control
knob in the for about one (1) minute after the pilot
is lit. Release knob, and it will pop back up. Pilot
should remain lit. If it goes out, repeat steps 5
through 9.
• If the control knob does not pop up when
released, STOP and IMMEDIATELY call
a qualified service technician or gas
supplier.
• If the pilot will not stay lit after several
tries, turn the gas control knob to "OFF"
and call your service technician or gas
supplier.
10. Turn gas control knob counterclockwise to
the "ON."
11. Close louver front assembly.
12. Turn on all electric power to the appliance (if
applicable).
13. Set ON/OFF/REMOTE switch to desired setting.
1. STOP! Read the safety information above.
2. Set REMOTE/OFF/ON switch to OFF.
3. Turn off all electric power to the fireplace (if applicable).
4. Lower louver front assembly.
5. Push in gas control knob slightly and turn clockwise
to "OFF."
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
6. Wait ten (10) minutes to clear out any gas. Then smell
for gas, including near the floor. If you then smell gas,
STOP! Follow "B" in the safety information above. If
you do not smell gas, go to the next step.
7. Find pilot — Follow metal
tube from gas control. The
pilot is behind the second
log on the left side.
TO TURN OFF GAS TO FIREPLACE
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This fireplace has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions ex-
actly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it; call a qualified
service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service techni-
cian to inspect the appliance and to replace any part
of the control system and any gas control which has
been under water.
LIGHTING INSTRUCTIONS
1. Set REMOTE/OFF/ON switch to OFF.
2. Turn off all electric power to the fireplace if service is to
be performed (if applicable).
3. Lower louver front assembly.
STANDING PILOT LIGHTING INSTRUCTIONS