Avery Dennison SNAP 500 Short Feed - Manual (Page 15)

581396-1.2.doc SNAP 500 Short Feed Addendum
3. Set the smooth rollers aside. Remove the old O ring belts from the two knurled rollers. Replace with new O ring
belts.
OLD BELTS
NEW BELTS
4. You are now ready for re-assembly. However, the roller springs (shown in step 2) must first be compressed
before the smooth rollers can be assembled. Using the spring holder tool, insert the pull wires into the smooth roller
slots. Compress the springs by sliding the spring holder tool back until the lip edge catches on the lip edge of the
roller bracket and locks into place.
SPRING
HOLDER
TOOL
INNER
ROLLER
SUPPORT
PULL
WIRE
LIP EDGE