Brinly PA-40 BH Plug Aerator - Manual (Page 9)

L-1762 Rev. E 9
22
25
25
30
11
23 30
32
27
16
19
14
11
32
10
7a. Push the Axle Assembly (10) through the left
side plate as far as possible and rotate so the
hole in the flat plate faces to the rear as shown.
Install the Lift Handle Assembly (11) with the
welded tube facing out, to the Axle Assembly
(10). Secure with Hex Bolt (19) and Nylon Lock
Nut (32).
7b. Slip Handle Grip (14) over end of Lift Handle
Assembly (11). NOTE: Soapy water will ease
the assembly.
7a. Pre-assemble axle bolt. Install Flat Washer
(25) over Hex Bolt (22). Slide assembly through
wheel, note orientation. Place Flat Washer (25)
and Hex Nut (30) on Bolt and thread on as far as
possible, still allowing wheel to rotate freely.
7b. Install through holes in Lift Handle (11) and
Axle Assembly (10). Install Lock Washer (23)
and Hex Nut (30). Tighten inside Hex Nut while
holding Hex Nut next to wheel stationary.
7c. Insert Transport Pin (27) in rear hole same
side as Lift Handle Assembly (11) as shown.
Secure with Nylon Lock Nut (32).
NOTE: Make sure the Axle Assembly
Flat Plate and Lift Handle Assembly are
pointing towards the rear as shown.
IMPORTANT: The wheel hub is offset to one
side. Make sure the extended offset is installed
toward plug aerator.
Figure 7
Figure 8
HANDLE ASSEMBLY
WHEEL ASSEMBLY
ASSEMBLY
(19)
Hex Head Bolt, 5/16" x 1-1/2"
Qty. 1
(27)
Transport Lock Pin
Qty. 1
(32)
Nylon Lock Nut, 5/16"
Qty. 1
(32)
Nylon Lock Nut, 5/16"
Qty. 1
(14)
Handle Grip
Qty. 1
(Not To Scale)
(25)
Flat Washer, 5/8"
Qty. 4
(23)
Lock Washer, 5/8"
Qty. 2
(30)
Hex Nut, 5/8"
Qty. 4
(22)
Hex Bolt, 5/8" x 4"
Qty. 2