Brinly LVS-33 BH PolyVAC System - Manual (Page 24)

L-1771-D
Step 20.
TRACTOR PREPARATION
The Mower Deck Housing does not have to be
closely fitted to your mower deck, or airtight. It
just needs to be installed in front of the mower
deck opening where the grass exits using
existing holes in mower deck whenever
possible. Templates have been provided to give
you a starting point and guide for completing
this step. Depending upon the manufacturer of
your tractor and the year, variations may occur.
The guides can be used to help you get started.
It is recommended that you remove material a
little at a time to obtain the best fit.
Select and cut out template according to
Tractor Model and Mower Deck cutting width.
NOTE: Templates are for specific Tractor
Models. If yours is not included, proceed to
"Tractor Preparation" (49) and choose Option 1
(Step 22) or 2 (Step 22) that best fits your
Tractor Mower Deck and mount the Mower
Deck Bracket. Next, position Mower Deck
Housing under the Bracket as shown in Option
3 or 4.Trace around Mower Deck opening using
a marker pen.Cut out using a jig saw or key hole
saw.
Position and tape template over Mower Deck
Housing using two pencils for alignment as
shown on templates and Step 20.
Mark outline of template onto Mower Deck
Housing using a marker.
Cut Mower Deck Housing outline previously
marked using a jigsaw or key hole saw.
Remove Grass Deflector from Mower Deck.
NOTE: Keep Grass Deflector and reinstall
whenever your Lawn-Vac is not in use.
Determine the type of Mower Deck Bracket (96
or 99) based on Tractor Model and Mower Deck
width. Refer to Step 21 and to Chart for
recommended Options.
Position previously cut opening in Mower Deck
Housing to opening of Mower Deck, aligning
bottom of Mower Deck Housing to bottom of
Mower Deck.
Step 21.
42.
43.
44.
45.
46.
47.
48.
#2 Pencil holes for alignment
Mark and cut outline
Small Mower Deck Bracket(99)
Large Mower Deck Bracket (96)
93
24.