DirecTV D10 - Manual (Page 46)

Other Information
44 Chapter 5 Chapter 5 45
Index
FCC Customer Information
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back or bottom side
of this equipment is a label that contains, among other information, a product identifier in the format US:G95XXXXXXXXX. If
requested, this number must be provided to the telephone company.
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable
FCC part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular RJ11 plug is provided with
this product. It is designed to be connected to a compatible modular jack that is also compliant. See installation instructions for
details.
The Ringer Equivalence Number (REN) is used to determine the number of devices that may be connected to a telephone line.
Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all
areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line,
as determined by the total RENs, contact the local telephone company. The REN number is located on the label of this product.
If this digital satellite receiver (modem) causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company
will notify the customer as soon as possible. Also, you will be advised of your right to file a compliant with the FCC if you
believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation
of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary
modifications to maintain uninterrupted service.
If trouble is experienced with this digital satellite receiver, for repair or warranty information please refer to the appropriate
section of this manual. This product is not user serviceable. If the equipment is causing harm to the telephone network, the
telephone company may request that you disconnect the equipment until the problem is resolved.
Connection to party line service is subject to state tariffs and may not be allowed. Contact the state public utility commission,
public service commission or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure that the installation of this digital
satellite receiver (modem) does not disable alarm equipment, consult your Telephone Company or qualified installer.
FCC Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Trade Name: DIRECTV
Model(s): D10
Equipment Classification: TV Interface Device
Responsible Party: DIRECTV, Inc.
2230 E. Imperial Hwy
El Segundo, CA 90245
Telephone: 1-800-DIRECTV (347-3288)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect this equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.