Code Single-Bay Battery Charger - Manual

14870 S. Pony Express Rd. #200 Bluffdale, UT 84065
www.codecorp.com
(801) 495-2200
A red LED = reader/battery is charging
A green LED = reader/battery is fully charged*
*Note: In certain reader configurations, the radio is required to
always be on, therefore requiring a constant power draw. In these
instances, while the power draw is minimal, the LED light may
never turn green when charging a reader.
Charging Status:
The Single Bay Battery Charger has an LED light to indicate the charging status of
the reader. Once the reader is engaged with the charging clips - the LED will turn red
or green. (Figure 3)
© 2012 Code Corporation. All rights reserved. C003838_03_SingleBayBatteryCharger_Quickstart
14870 S. Pony Express Rd. #200 Bluffdale, UT 84065
www.codecorp.com
(801) 495-2200
© 2012 Code Corporation. All rights reserved.
Figure 3
Installing the Single Bay Charger to the Wall Mount:
1. Attach the wall mount to a wall (because surface types differ, screws are not
included to secure the wall mount to a wall).
2. Using the two screws provided, follow the step shown in Figure 4 to install the
charger to the wall mount. Once the charger is installed, set a reader onto the
charging post to charge a reader. (Figure 5)
Figure 4 Figure 5
A red LED = reader/battery is charging
A green LED = reader/battery is fully charged*
*Note: In certain reader configurations, the radio is required to
always be on, therefore requiring a constant power draw. In these
instances, while the power draw is minimal, the LED light may
never turn green when charging a reader.
Charging Status:
The Single Bay Battery Charger has an LED light to indicate the charging status of
the reader. Once the reader is engaged with the charging clips - the LED will turn red
or green. (Figure 3)
Figure 3
Installing the Single Bay Charger to the Wall Mount:
1. Attach the wall mount to a wall (because surface types differ, screws are not
included to secure the wall mount to a wall).
2. Using the two screws provided, follow the step shown in Figure 4 to install the
charger to the wall mount. Once the charger is installed, set a reader onto the
charging post to charge a reader. (Figure 5)
Figure 4 Figure 5
C003838_03_SingleBayBatteryCharger_Quickstart