Compuprint 3046 Installation - Manual (Page 2)

Installation Guide
1 Unpacking the Printer
a- Packing and Unpacking
1- Make sure the following parts are included while unpacking the printer, and no parts are
damaged.
2- Preserve the packing material properly for use in case of future printer transportation.
13
12
11
14
10
9
8
1
2
7
3
4
5
6
Figure 1
b- Protection Material
Remove the protection material before assembling printer: Refer to figure 1, and remove the
protection material pointed out by numbers 1 to 7 on the printer outside and 8 to 14 inside the
printer, and preserve them for the future transportation.
After removing the protection material, take out the front paper chute board from the package,
and push both hooks gently along the track into both gap locations of printer. You should hear
a “click” when the hook snaps into the gap.
2 Installing the Printer
a- Ribbon Cartridge Installation
1. Make sure the printer is turned off before inserting the ribbon cartridge.
2. Remove the transparent cover part first, then hold the plastic hooks on both sides of the
sheet holder and pull upwards to remove the transparent sheet holder. After that, move
the print head to the middle of the printer.