Dyna-Glo LP Gas Grill DGP350NP - Manual (Page 26)

LP Gas Grill
OPERATION INSTRUCTIONS
24 25
Lighting The Grill
Before first use
Remove all hangings or plastic straps, if present.
Before you cook on your new gas grill, it is important to clean your grill with heat.
To do this, operate the grill for approximately 15 minutes with the lid closed and the
control knob in the highest position. This will clean the internal parts by burning off any
residue and odor from the manufacturing process.
CAUTION: If the flame extinguishes accidentally during ignition or operation,
immediately TURN OFF the cylinder valve and then TURN OFF the control knob.
LIGHTING INSTRUCTIONS
Warning: Do not lean over grill when lighting.
Read instructions before lighting.
1. Check that the control knobs are in the off position.
2. Open valve at tank fully by turning counterclockwise.
3. Open lid during lighting.
4. Depress and turn control knob counterclockwise from off position,
past the ignite position, to the high position. You may need to
repeat several times to ignite the burner.
If ignition does not occur in 5 seconds, turn the control(s) off,
wait 5 minutes, and repeat the lighting procedure.
If the burner still does not light, check that there is gas in the cylinder
and follow the match lighting instructions.