Daktronics BB-2102 Tuff Sport Four-Sided Basketball LED Scoreboard - Manual (Page 19)

Mechanical Installation 13
3.9 Attaching Corner Shrouds
Reference Drawing:
4-Side Installation Details ....................................................................... Drawing A-154598
Note: Make sure all power and signal wires are connected on top of the scoreboard
before attaching the corner shrouds. Refer to Section ‎4.2.
The corner shrouds are metal panels that cover the outside corners of the four-sided assembly
and hide the wiring between sections. Separate shrouds are provided for each display tier.
Refer to Detail C of Drawing A-154598 in Appendix E for corner shroud installation details.
1. Position and attach angle brackets to the side channel of each scoreboard, ad panel, or
message center section with the #10 screws provided.
2. Position each corner shroud across the appropriate corner and mark the locations of
the holes on the angle brackets.
3. Drill 5 /
32
" holes as a guide for the screws.
4. Secure the corner shrouds to the corners with the #10 screws provided.
3.10 Attaching Suspension Cables
Reference Drawings:
Sling Set: Standard 10' Square 4-Side Scoreboards ............................. Drawing A-181903
Sling Set: Standard 8' Square 4-Side Scoreboards ............................... Drawing A-181935
Sling Set: Standard 10' 4-Side Scoreboards .......................................... Drawing A-268195
The roof of the facility and any structures fabricated for suspending the scoreboard, as well as
the suspension cable slings, must be designed by or inspected and approved by a qualified
engineer. Drawing A-181903 and Drawing A-181935 in Appendix E show recommended
component specifications of cable slings (these are not typically provided by Daktronics).
Note: Refer to Drawing A-268195 for BB-2146 and BB-2147 models.
If the scoreboard is to be static mounted, that is, suspended from fixed cables without a hoist:
1. Attach the cables to the four lift tubes on the corner braces of the frame. The cables
may be connected together to make two attachment points, or all four cables may
attach to the roof trusses or the mounting structure.
2. Hang the top ends of the cables over the sides of the scoreboard to get them out of the
way yet keep them accessible when hooking up.
3. Lift the scoreboard using an appropriate means, such as a chain hoist, to the correct
suspension height.
4. Attach the top ends of the cables to the previously prepared mounting points.
5. Remove the temporary lifting apparatus and level the scoreboard by adjusting the
turnbuckles built into the slings.