Daktronics M SERIES - Manual (Page 13)

HOIST OPERATION SCREEN
06 HOIST OPERATION SCREEN
HOIST OPERATION Screen Layout
The HOIST OPERATION screen (Figure 4) allows the
user to select a hoist, jog a hoist, set up, and run the
hoist to different preset positions and speeds.
This screen has the following information for each hoist
connected to the system:
1. CURRENT HOIST NAME
2. UPPER LIMIT
3. CURRENT POS. (position)
4. CURRENT SPD. (speed)
5. CURRENT LOAD
6. TARGET POS. (position)
7. TARGET SPEED
8. LOWER LIMIT
Selecting Hoists
Different hoists can be selected by using the PREVIOUS
HOIST or NEXT HOIST buttons or by pressing the
CURRENT HOIST number and entering the desired
hoist node number. Note that the node number may be
different from the line set number.
JOG HOIST
First select the desired hoist. Press the HOIST SPEED
button and enter the appropriate speed using the
on-screen keyboard. Press the JOG HOIST UP or JOG
HOIST DOWN button, depending on the direction the
hoist needs to go.
If the wrong jog option is mistakenly selected, simply
press and release the button to deselect that option.
The EXECUTE MOVE button must be pressed and held
to execute the move. If the EXECUTE MOVE button is
released, all hoist movements will stop.
Figure 4: HOIST OPERATION Screen
13