Diamondback Fitness 910Ub - Manual (Page 10)

10
18. Remove the five (5) Allen bolts (C‐6), four (4) flat
washers (C‐7) and one (1) curved washer (C‐8)
from the main frame and set aside.
19. Orient and slide the console mast cover (D‐2)
upward onto the console mast (C) and hold in
place, half the way up the mast.
20. While supporting the console mast, carefully
join the main wire harness connectors (C‐9 and
C‐9). Make sure the connection is complete.
21. Slide the console mast (C) into place onto the
main frame (taking care to not damage the
cables).
22. Install the two (2) bolt and flat washer
assemblies (C‐6 & C‐7) through the lower holes
on each side of the console mast and into the
frame. Tighten firmly.
23. Re‐install hex bolt and curved washer assembly
(C‐6 & C‐8) into the front of the console mast.
Tighten firmly.
24. Slide the console mast cover (D‐2) downward
and snap into place.
25. Re‐install the two (2) hex bolt and flat washer
assemblies (C‐6 & C‐7) into upper holes in the
sides of the console mast.