Digi-Star EZ 2000/V - Manual (Page 4)

Digi-Star Model EZ2000/EZ2000V 2. System operation
2
2. System operation
! EZ2000 shown - EZ2000V operation is the same.
! LB and KG annunciators are located along right hand edge of the 2000V display.
TURNING ON THE SCALE Press .
A brief message will be displayed (such as HELLO).
The scale then enters the GROSS weighing mode.
GROSS mode displays the weight change since the
unit was last ZERO/BALANCED.
Pressing a second time during normal system
operation starts the self test.
TURNING OFF THE SCALE
Press .
TO ZERO BALANCE THE SCALE
Press and then within three seconds, press .
The ZERO key will "balance off" empty trailer, bin,
or platform weight.
The ZERO message is displayed and the scale is
placed in the GROSS mode.
Pressing only the ZERO key will cause the
message: TO ZERO/BALANCE PRESS NET/ GROSS - THEN ZERO
to be displayed.
If the supply power is below the low battery
threshold (10.5 Volts),the message INDICATOR CANNOT BE
ZERO/BALANCED-LOW BATTERY VOLTAGE is displayed. The
message LO BAT will be periodically shown on the
display (approx. every five seconds) to alert the
operator of the low battery condition.
Loss of power does not affect the Zero/Balance or
Setup/Calibration values.
HELLO
ZERO
1
2