DNF Controls 4000CL-LPH - Manual (Page 11)

1 1 1 1 4000CL-LPH, 400 Clip Fast Access System, Louth Phillips Protocol
b. RECEIVE CUE LIST FUNCTION
The RECEIVE CUELIST function allows you to receive your list of Cue Points from a
PC or from another ST300. Transfer to a PC requires OpSuite 3.0 software, which runs
on a Windows-based computer. Contact DNF Controls for more information.
1) To Receive Cue Points from the ST300
a) Connect the VTR4 connector on the back of the ST300 from the VTR4
connector of the transmitting ST300 using RS422 9-pin cable with TX
and RX lines crossed.
(A “Turnaround” Cable)
b) Press
[MENU] and scroll the Wheel to “Receive CUE List?
YES=Enter, Exit=ESC.”
c) Press
[ENTER] from start receiving.
The Display shows “Waiting to receive” on the first line.
d)
When the Transmitter is ready, transfer starts automatically.
The Display now shows “Receiving cuelist.”
e)
After the transfer is over the display shows “Done-Success! Press any
key…”
f)
Press any key. The display shows “Receive cuelist?” message.
g) Press
[ESC] to exit the MENU mode.
2) To Receive Cue Points from the PC
a)
Connect the VTR4 connector on the back of the ST300 to one of the
COM ports on the PC using RS422 to RS232 adapter
b)
Repeat steps b-g of the RECEIVE CUE POINTS from the ST300
section.