DNF Controls SW32PS-RCP - Manual (Page 8)

Use the table below to set the switches for the desired ID:
SW6 SW5 SW4 SW3 SW2 SW1
ID: 01 Left Left Left Left Left Right
ID: 02 Left Left Left Left Right Left
ID: 03 Left Left Left Left Right Right
ID: 04 Left Left Left Right Left Left
ID: 05 Left Left Left Right Left Right
ID: 06 Left Left Left Right Right Left
ID: 07 Left Left Left Right Right Right
ID: 08 Left Left Right Left Left Left
ID: 09 Left Left Right Left Left Right
ID: 010 Left Left Right Left Right Left
c. Connect DB9F side of supplied power supply into the connector labeled
“Power”. Then connect the IEC to Edison cable to the power supply.
Connect the power cable to 90 VAC to 240 VAC source.
Caution: Do Not Hot Plug the Power Supply DB9F connector!
Installation is complete.
4. CONNECTION DIAGRAM
TYPICAL CONNECTION DIAGRAM
Page 4 4 O O f f 1 1 3 3 SW32PS-RCP Port Switcher Controller