DR Power Power Tiller Cultipacker Roto-Hog - Manual (Page 15)

Contact us at www.DRpower.com 15
Chapter 4: Maintaining The Optional Accessory
Regular maintenance is the way to ensure the best performance and long life of your OPTIONAL ACCESSORY. Please refer to this
manual for maintenance procedures.
MAINTAINING THE DR POWER SPREADER
Regular Maintenance Check List before each use
CHECK FOR LOOSE FASTENERS
1. Before each use make a thorough visual check of the Spreader for any bolts and nuts which may have loosened. Retighten any
loose bolts and nuts.
CHECK FOR WORN OR DAMAGED PARTS
1. Check for worn or damaged parts before each use.
2. Repair or replace parts if necessary.
CLEANING
1. Rinse inside of Hopper and exterior of Spreader and dry off before storing (even though the Spreader Motor is sealed, avoid
spraying the Motor and wires if possible).
2. Clean out any build up of material from the Hopper Closure Plate.
3. Clean any build up of material from your ROTO-HOG Tiller.
Storage
1. Rinse inside of Hopper and exterior of Spreader and dry off before storing (even though the Spreader Motor is sealed, avoid
spraying the Motor and wires if possible).
2. Store in a clean, dry area.
Follow all warnings, cautions etc. from the material manufacturers for proper cleaning and disposal practices before cleaning your
equipment.
When performing any maintenance on the DR Spreader Attachment when the unit is still attached to the tiller, you must first make
sure the switch on the tiller control box is in the “off” position and then disconnect the wire harness of the motor mount assembly.