Echo Bear Cat 75360 2002 - Manual (Page 6)

Bear Vac Manual Insert
ATTACH TY-RAP
CLAMPS (QTY. 6) AFTER
DESIRED HANDLEBAR
HEIGHT IS ACHEIVED
The handlebars are shipped in
the lowest position. If desired
the handlebars can adjusted to
four different positions.
NOTE
5/16" X 1-3/4"
CARRIAGE BOLT
HANDLEBARS
ADJUSTMENT
HOLES
5/16" FLAT
WASHER
5/16" NYLOCK
LOCKNUT
aDJUSTing THE HanDLEBaR HEigHT
The handlebars of the Bear Vac can be mounted in four different
positions. The handlebar is shipped in its lowest position. If the
handlebar needs to be raised, follow the instructions below.
adjusting the handlebars:
Loosen the 5/16” bolts holding the lower handlebar onto the
Bear Vac.
Remove the handlebar assembly from the frame of the
Bear Vac.
Move the handlebar to the desired position on the frame.
Reconnect the handlebar to the frame using the 5/16”
hardware. 1.
2.
3.
4.
nEw HanDLEBaR COnfigURaTiOn
The Bear Vac is now shipped with a upper handlebar connect-
ed to the lower handlebar. Both handlebars are connected to
the machine. Refer to the next section to adjust the handlebar
height.