Directed Electronics BOA 165B - Manual (Page 30)

27 © 2 0 0 4 D i r e c t e d E l e c t r o n i c s , I n c .
C Co on nttrro oll M Mo od du ulle e P Prro og grra am mm miin ng g
Depending on the vehicle, use the following data with the
instructions to program your system. These wire loops are found
at the side of the control module.
D Diieesseell M Mood dee ((B BL LU UE E)) - Cut this loop if you have a diesel vehicle.
When cut the remote start will start the engine about 30 seconds
after pressing the button twice.
Uncut – Gas Mode
Cut – Diesel Mode
V Voollttaaggee M Mood dee//T Taacch hoom meetteerr M Mood dee - Default is voltage mode. The
control module will automatically look at the tachometer input
during normal driving. If it finds a valid tachometer signal the
module will use tachometer mode, otherwise the module will use
voltage mode (battery voltage will rise after the engine starts).
To program tachometer mode, start the engine and let it run for
at least 30 seconds. If the tachometer is seen by the control
module, it will enter tachometer mode, and will monitor the
tachometer input for the next startup.
The system is programmed to attempt two starts using
tachometer mode. If after the second start attempt the control
module did not see a tachometer input the system will attempt
to start a third time using voltage mode.
START START
PROG PROG
ARM ARM
DISARM DISARM
STOP STOP