Elfa Top Track and hang standards - Manual (Page 4)

www.elfa.com
Sida 4 av 13
1
2
Top Track, Hardware and Hang Standards
Install Hang Standards, Brackets Click In and Top Track Cover
Insert the hang standards in
the top track notches.
1. Group hang standards together and insert
bracket click in at the appropriate height
based on your space plan.
2. Slide the hang standards to their approxi-
mate position on the top track. Refer to your
custom space plan for placement of the
hang standards, if you have one.
3. Hang standards should be a minimum of
1/2”/10 mm from the ends of the top track.
Top Track Cover Installation
1. Because the top track cover is placed between the hang
standards, the shelves must be in place to ensure the
spacing between the hang standards is set.
2. Start with long pieces first. Place the bottom of the top
track cover into the bottom of the top track, then ease the
top of the top track cover into the top of the top track.
3. Measure the area on the top track where smaller pieces
of the top track cover are needed.
4. Measure and mark the top track cover where the cuts
need to be. The cover is easily cut in a straight line with
scissors.
5. Do not overlap segments of the top track cover.
You should install your top track cover after you
have completed all the installation steps. Please
refer to the instructions once you have placed all
of your shelves and your drawers and are satisfied
with the positioning of your solution.
Click In
Brackets shown
Elfa Lumi AB
Elfagatan 5, 593 87 Västervik
Tel: +46 392-389 10 Fax: +46 392-361 25. E-mail: [email protected]