Foxconn FlamingBlade - Manual (Page 39)

32
3
onChip IDe Device
► Intel ICH10 SATA Mode
This item is used to set the Serial ATA Mode. Setting options: [IDE]; [RAID]; [AHCI].
The SATA interface is controlled by Intel® south bridge chip.
► Legacy Mode Support
There are Native IDE and Legacy (or compatible) IDE modes. Legacy mode supports OS
through legacy IDE driver. Most SATA functions are not supported in Legacy mode, like SATA
II 3G, NCQ, Hot Plug and etc, and Native mode supports SATA II 3G, NCQ, and Hot plug.
This item is used to enable/disable the Legacy IDE mode support for the SATA ports. Certain
OS is not supported under Native mode, and must choose Legacy mode.
► Turbo Memory Support
Turbo Memory (Robson Technology) features an integrated disk cache using flash memory
in order to speed up disk access and also save energy. It uses non-volatile memory (Flash
memory) to increase system responsiveness, make multi-tasking faster, and extend battery
life.
This item is used for supporting the Turbo Memory.
► Jmicron 363 PATA and eSATA(for Flaming Blade)
You may set your PATA and eSATA to IDE mode or RAID+IDE Mode or AHCI+IDE mode(AHCI
for eSATA, IDE for PATA). We are using JMicron chip to control PATA and eSATA devices.
► Jmicron 368 PATA(for Flaming Blade GTI)
You may enable/disable your PATA device. We are using JMicron chip to control PATA device.
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Device
Intel ICH10 SATA Mode Item Help
Legacy Mode Support Disabled
x Turbo Memory Support Disabled Menu Level ►
Jmicron 363 PATA and eSATA IDE Mode
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
IDE