Fox intelligent stepping – Foxconn G31MG Series User Manual
Page 32
25
3
► Smart Power LED
Smart Power LED is a feature built on your motherboard to indicate different states during
Power On System Test (POST). The LED is located at the front panel, and it displays POST
state by different long-short blinking intervals. You can always leave this state enabled.
► Smart Boot Menu
When PC starts, if [Enabled] is selected, a Boot Menu will be automatically displayed to inform
you to select a boot device. If no device is selected, the first device will be used. If [Disabled] is
selected, then PC will ask you to press [Esc] key to get into Boot Menu. This setting simplifies
multiple boot devices user from pressing [Esc] key to enter boot menu.
► Current CPU Speed
This item displays the current CPU speed.
► Current FSB Speed
This item displays the current Front Side Bus speed.
► Current CPU Multiplier
This item displays the current CPU Ratio.
► Current DRAM Speed
This item displays the current DRAM speed.
fox Intelligent Stepping
► FSB 1600 CPU Support ( Appears only if CPU supports FSB 1600)
This item will show and provide more options if your CPU is supporting FSB1600. If it is ena-
bled, then FSB is set to 1600MHz and you can not overclock further. If it is disabled, then you
System Status
Power LED Status
Stop Blinking Condition
Normal
Always On
Always On
No Memory
Continue blinking On (1sec.), Off (1sec.)
Reboot & Memory OK
No Display
Continue blinking On (2sec.), Off (2sec.)
Reboot & Display OK
Post Error Message
Quick blinking twice (1/3sec. On, 1/3sec. Off),
one long On (1sec.), continuously.
Enter Setup or Skip
No CPU Fan
Continue blinking On (1/2sec.), Off (1/2sec.)
Reboot & Fan OK
Phoenix - AwardBIOS CMOS Setup Utility
Fox Intelligent Stepping
FSB 1600 CPU Support
[Disabled]
Item Help
Fox Intelligent Stepping
[Default]
CPU Clock
266MHz
Menu Level ►
PCI Express Clock
100MHz
Spread Spectrum
Enabled
CPU Multiplier Adjust
[12 X]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Disabled