GAMMA PROGRESSION Floor Stand - Manual

Base Foot
Lock Nut
Endcap
Bottom Plate
Upper Support Column
Lower Support Column
Column Height
Lock Screws
Leg Attaching
Button Head
Cap Screws
Base Foot
Nut
Leg Tube
Base Foot From
Progression
Machine
Support Plate
Support Plate
Attachment Bolts
Upper Support Column
Flange Plate
PROGRESSION Floor Stand
ASSEMBLY INSTRUCTIONS
Base Assembly
Remove the Lower Support Column from the carton. This is the larger of the two posts. Align
the holes in the Base Leg with the matching holes in the Lower Support Column Post Plate.
Loosely secure the Base Leg with one button head cap screw, inserted through the Lower
Support Column Post Plate, the hole in the leg and threaded into the Bottom Plate. Repeat this
procedure for the three remaining Base Legs.
Once all Base Legs are in place, securely tighten the cap screws. Place one lock washer and
one locking nut on each screw, where it protrudes from the Bottom Plate, and tighten securely
with the 10MM Box Wrench.
Support Column Assembly
Insert the Upper Support Column into the Lower Support Column / Base Leg assembly. Leave
the Upper Column extended about 1/2 of its length and lock in place with the two Column Height
Lock Screws located at the top of the Lower Column Support. Position the Support Plate over
the Upper Support Column Flange Plate and align the four holes. Secure the Support plate with
the four button head cap screws provided.
Attachment of Progression Machine Base
Remove the four feet from the base of the Progression machine and rest the base on the
Support Plate (for Progression ST machines position the turntable end over the notched end
of the support plate). Align the four corner holes of the Progression machine base with the four
corner holes of the support plate and secure the base of the machine with the four feet and
large washers provided with the Floor Stand.
Base Foot Height Adjustment
Each foot of the Floor Stand can be adjusted to compensate for uneven surfaces.
Remove the Endcap from the leg to be adjusted, loosen the Base Foot Nut located inside of
the leg tube with the 10MM wrench. Adjust the foot to the desired level by turning the hex nut
located between the Base Foot and the the Leg Tube. Tighten the hex nut inside the leg tube
to lock the foot in place. Replace the Endcap.
LIMITED WARRANTY
GAMMA SPORTS ("GAMMA") warrants to the original purchaser that the GAMMA Progression Floor Stand ("EQUIPMENT")
purchased is free from defects in materials and workmanship for a period of five (5) years from the date of original purchase.
Should any defects develop under normal use within the specified time periods, GAMMA will at its option, repair or replace
the defective EQUIPMENT provided it is returned to GAMMA prepaid at the purchaser's expense. This warranty does not apply
to any damage or defect caused by negligence, abuse, misuse, unauthorized alteration, shipping, handling, or part wear and
tear as a result of normal use.
GAMMA's obligation under this warranty is limited to repair or replacement of defective EQUIPMENT, and no one is authorized
to promise any other liability. GAMMA shall in no event be liable for any incidental or consequential damages.
To return defective EQUIPMENT, a return authorization (RA#) must be obtained from a GAMMA customer service
representative by calling 1-800-333-0337. The RA# must be marked on the outside of the shipping carton being returned. All
returns must be shipped prepaid by the customer to GAMMA. Please retain the original shipping carton and packing materials
for any future shipments.
MPFS Manual Issue 2 - 122299